motorola programming cable pinout mcs2000

It gives a reason to cut off USB cables from old mice and keyboards and keep them around for cables like these. These cables sell on ebay for as much as $60. In MOTOROLA GP-340 connector the output voltage is limited to approximately 3 Volts. The corresponding programming cable connector was designed and tested by Belu Daniel (Romania). The programming cable is powered from the radio socket. The one on the right was purchased by another ham for more than $30. MOTOROLA mobile CM series radios may be also programmed through the front mic socket. The left cable is the one just made for under $10. However the back will program everything. I was told by a Motorola rep that the front microphone connector will not program everything on the radio and is not recommended because it is some proprietary system Motorola has. Some cheap cables might not follow the standard color scheme. Some cables may be swapped depending on who made them.

Consumers should expect a fair deal from their cable company, with reason-able rates that fairly reflect the costs of doing business 2. Some people have mentioned that the green and white wires where swapped, so you might want to check your USB connector before making the assumption that the white and green wires are what they really say they are. The FCC’s Cable Consumer Bill of Rights 1. As Interface make sure to get a FTDI of the type FS232RL. Cut the cable in half and solder it together with the other components as pictured above.

Lower left side of the connector is pin 1 All you need is an old CAT5/6/7 network cable, a 1N4148 diode and a few wires. Upper left side of the connector is pin 2 Looking at the back of the radio the connector facing you the pins are as follows: Cut the one side of the USB cable that is not needed. This needs a simple USB cable with no other parts involved besides the PMLN5072 connector.

Motorola programming cable pinout mcs2000